Logitech G433 Headset Pivot Point Fix

This fix is printed in 2 halves per side.

Just print 1 of each Side1.4_v1, and Side2.4_v1 to fix one side of the headphones. I haven't yet fixed the right hand side since it hasn't broken, so I'm not sure if it will work for the right hand side, but it probably will.

Requires 4 larger screws approx. 10-12 mm long and 3mm thread diameter
Also requires 1 smaller screw approximately 7-8mm long and 2.3mm thread diameter

Please note:

These screws were salvaged from a dead inkjet printer so have fun finding equivalents or modifying the f3d files :)

This fix works even if the metal part has snapped off at the bend, although it is tricky to get it lined up.

No soldering /messing with electronics required unless the old plastic piece does not break away like mine did.