Thingiverse
Logitech K400+ wall support
von octaneita
354
Downloads
285
Likes
1
Makes
Wall support for Logitech K400+.
I've added the left support, for the right one just mirror the left.
If you feel the keyboard too floppy, add a support in the middle.
The keyboard is confined by the two walls and by the keyboard's bottom rubber pads, so will not fall down. The fit is quite tight but if you feel you need to much force to extract it, just file a bit the bottom hump.
I don't know why, but I had to scale down to 0.1 both models before printing.
I've added the left support, for the right one just mirror the left.
If you feel the keyboard too floppy, add a support in the middle.
The keyboard is confined by the two walls and by the keyboard's bottom rubber pads, so will not fall down. The fit is quite tight but if you feel you need to much force to extract it, just file a bit the bottom hump.
I don't know why, but I had to scale down to 0.1 both models before printing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
