Logitech K800 Inner Key clip/hinge

Replacement inner clip for Logitech K800 keyboard.

Best printed by PLA; PETG is slightly worse. I printed it on Prusa mk2 FDM printer with 0.4mm nozzle, but it requires a lot of postprocessing with a knife, especially the lower part. It would be much better with 0.2mm nozzle, unfortunately I don't have one and I was in a hurry to fix my keyboard. SLA would be probably best option.
Use the smallest layer height as possible, I used 0.1mm.

It's quite difficult to print because of small pins, I used support without any contact distance and then I removed the supports with a knife. It might be better with a smaller nozzle, I'll see when another key will break. Definitely you need to adjust it a little bit by small knife. I didn't do any more postprocessing.