Thingiverse
Logitech Mouse Charging Dock
von PuTaTuo
5
Downloads
3
Likes
0
Makes
A flat charging dock for Logitech mouse.
Stick the removable round piece that comes with the mouse to the dock. Drill two holes accordingly, then solder the wires to the two magnets.
Make sure the positive is on the right, and the negative is on the left. I wrapped the magnets with a strip of aluminon foil to create a soldering area and increase the touch point a little bit as well.
Stick the removable round piece that comes with the mouse to the dock. Drill two holes accordingly, then solder the wires to the two magnets.
Make sure the positive is on the right, and the negative is on the left. I wrapped the magnets with a strip of aluminon foil to create a soldering area and increase the touch point a little bit as well.
PuTaTuo veröffentlicht auch auf
47 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
