Slicer Discord
Logitech Streamcam Ultimate Cover – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

Logitech Streamcam Ultimate Cover

38 Downloads
11 Likes
20 Makes
Zum Modell
Hello there!Yet another Logitech Streamcam Cover you might say, but noI've stumbled across a lot of covers but none of them had all the things I was searching for, so I designed one myself, following all the functionalitiesFlare protection from above lightnings without compromising the maximum angulation of the cameraBounded camera cover, with a practical 3*2 magnet you can keep it over the camera or in front of it, without taking the piece awayA design that keeps the microphone usable, since it's not bad at all I use it when I'm in voice calls, with this design it can detect the voice well keeping the camera coveredThe assembly is simple, you just have to glue the two main pieces togheter and slide the camera cover into the guides after gluing two 3*2 magnets inside the corresponding holes, being careful with the orientation!That said you can slide the model onto the streamcam from the above and enjoy your all-around accessory
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Polycarbonate
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen