LOLIN32 Lite case (with reset button)

Small case for LOLIN32 Lite (ESP32), should snap easily in & out.
- base-open: pins are reachable at the bottom
- base-closed: pins at the bottom concealed

If you print the cover, lift it off the printing bed carefully - if the cover doesn't fit well (too tense), then file the corner insets a bit (just 0.1 to 0.2mm) so it snaps easier.

The two small tunnels inside of the cover guide the LED lights to the cover:



Note: your printer must be well calibrated (X/Y as well extrusion flow), otherwise this print won't work for you.

Nozzle: 0.4mm

Layer height: 0.2mm (or less)