Lollipop Stand (50 suckers)

So... I got roped into working a table at a figure skating event, and I was expected to sell candy. Lollipops, to be exact. If I'm going to do it, it's going to be done right! So I designed and printed these suckers (giggle).

Each one is a half-moon, and two can be printed on a 200mm x 200mm bed. They are 150mm high. The holes are octagonal and able to accept a 6mm wide cylinder stick, and the spacing is 20mm (~7/8" diameter) on center for the heads. the holes are on about a 20 degree downward angle, so the candy won't fall out. The shafts are 50mm long (~2"), and are pass-through, meaning any dirt inside the hole can be pushed through to the back, and longer handles can carry-on through the holder into the center of the stand.

There's a 20mm (~7/8") foot on the sides and front to prevent an imbalance as the candy is removed or inserted. There's even a 1mm (~3/64")wide slot by 100mm (~4") long in the top, 20mm (~7/8") deep for a cardstock sign to be slid inside for the price or p