MakerWorld
Other Toys & Games
Go to Model
lollypop toy
60
Downloads
81
Likes
39
Makes
I made a funny lollypop toy. Printing and assembling processes are both quite simple.It be appropriate for lollypop (diameter less than 3cm and stick's diameter less than 3-4mm)hope you like it. Installation is as shown in the picture.Assembling the model requires a rubber band.Installation according to the corresponding part number. rubber band is being tightened as much as possible.This model was printed using PLA. (fill in 10,using a lower layer high (0.2mm),no support)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!