Thingiverse
Longboard Lowering Slammers
door BrendaEM
3
Downloads
3
Likes
0
Makes
These lowering shims to allow a longboard/skateboard deck to be lowered in three sizes, 5mm, 10mm, and 15mm.
Please Donate: https://www.patreon.com/brendaem
You likely will need longer fasteners. Nuts should be locking-type, such as nylon locking nuts.
Please make sure that there is no binding truck/board interference on your setup. By lowering your deck, you will need to watch more carefully for obstructions. Please check to make sure that your deck is strong enough for this setup.
I printed my slammers with ABS at 75% fill. I've have tested the 10mm, for the last few months, and am going to try the 15mm. The 15mm has extra support to avoid parallelograming.
Legal: Skateboarding and Longboarding is dangerous by nature. Use at your own risk. Please test in a safe place, away from traffic. Please wear safety gear, so you can keep riding.
"Slammed" was an term applied to a lowered Honda Ruckus.
Please Donate: https://www.patreon.com/brendaem
You likely will need longer fasteners. Nuts should be locking-type, such as nylon locking nuts.
Please make sure that there is no binding truck/board interference on your setup. By lowering your deck, you will need to watch more carefully for obstructions. Please check to make sure that your deck is strong enough for this setup.
I printed my slammers with ABS at 75% fill. I've have tested the 10mm, for the last few months, and am going to try the 15mm. The 15mm has extra support to avoid parallelograming.
Legal: Skateboarding and Longboarding is dangerous by nature. Use at your own risk. Please test in a safe place, away from traffic. Please wear safety gear, so you can keep riding.
"Slammed" was an term applied to a lowered Honda Ruckus.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
