Longboard wall mount

This is a wall-mount for the final generation of the boosted board. I assume this will work with any boosted board/ longboard that has trucks wide enough to fit on the mount. This mount is likely overbuilt but I wanted to reduce the likelihood of failure of the mount and the attachment to the stud in the wall.

Print settings I used
0.55 Nozzle
PETG (Hatchbox Black)
0.48 Layer height
25% infill
Supports: Yes
Wall Line Count: 4
ie. 2.2mm thick walls

Recommended Hardware:
2.5~3 inch coarse-thread screws