Longboard Wall Mounting Hooks

The original hook had the shape I was looking for. However I spotted a couple of weaknesses before I even printed it. First the mounting holes were moved from the outer small clips, into the inside of the bulk of the part. Second the part was made to be printable sideways on the print bed so that no layer adhesion problems arise with the tension between the board and the wall. Layers go longways and support the tension instead of being separated under load. And last, the size was adjusted for what I needed. I wanted to hold the board bottom away from the wall so that i can charge it on the hooks.

15% infill on ABS was enough to hold my electric longboard. 2x 1.5in drywall screws was enough to hold the weight without me worrying about it falling. Dont tighten them to the wall too much because 15%infill will crack.