Thingiverse
Longer Cube2 Level Check
door tdmeeks
3
Downloads
3
Likes
0
Makes
This Thing is designed to be printed on the Longer Cube2 as part of the leveling process.
The circles will only print correctly if the gap and level at any given corner is correct. The gcode file is included for convenience for first time users of the Longer Cube2.
It prints in just over six minutes.
There is no need to complete the entire print, each pass, for this Thing to be useful. As it is printing it can become readily apparent that some parts are not adhering well and the print can be aborted to immediately make adjustments to save time.
When proper leveling and gap is achieved, all the lines will be the same width. All circles will be round and all corners will be square.
The circles will only print correctly if the gap and level at any given corner is correct. The gcode file is included for convenience for first time users of the Longer Cube2.
It prints in just over six minutes.
There is no need to complete the entire print, each pass, for this Thing to be useful. As it is printing it can become readily apparent that some parts are not adhering well and the print can be aborted to immediately make adjustments to save time.
When proper leveling and gap is achieved, all the lines will be the same width. All circles will be round and all corners will be square.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!