Thingiverse
Longshot Top Rail
por DartKrafts
62
Descargas
42
Likes
1
Makes
This here is DartKrafts remix of the BlasterforgePH Nerf Longshot Top Rail of which were kind enough to give to the community. But alas, the community do not have enormous printers!
So DartKrafts took it upon their crafty little fingers and split it up into printable parts for the masses.
It has 5 parts +2. Front End Piece, Front Left, Front Right, Back Left, Back Right, plus two little joiner thingies.
4 M3 x 12mm black self-tapping screws are required. Just steal some from your large size mellow yellow Nerf blaster (Stampede, Longshot front gun etc)
The joiner thingies were left separate intentionally as designing them into the rail pieces would put them right on 200mm, a common print bed size for most. The joiners are marked with a 'T' meaning 'Top' as the height and width may look the same, but no, good sirs and madams, they are not. So insert the joiner with the 'T' facing... the top of the rail.
Please glue the joiners into the 'Back' pieces first. The front piec
So DartKrafts took it upon their crafty little fingers and split it up into printable parts for the masses.
It has 5 parts +2. Front End Piece, Front Left, Front Right, Back Left, Back Right, plus two little joiner thingies.
4 M3 x 12mm black self-tapping screws are required. Just steal some from your large size mellow yellow Nerf blaster (Stampede, Longshot front gun etc)
The joiner thingies were left separate intentionally as designing them into the rail pieces would put them right on 200mm, a common print bed size for most. The joiners are marked with a 'T' meaning 'Top' as the height and width may look the same, but no, good sirs and madams, they are not. So insert the joiner with the 'T' facing... the top of the rail.
Please glue the joiners into the 'Back' pieces first. The front piec
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
