Loona Lightstick Stand

This is designed to display your Loona lightstick horizontally.

Use the big stand at the top of the lightstick and the small one at the bottom to display at a slight angle. Swap them around to display flat (the radiuses won't match the lightstick, but will hold it just fine).

I printed this on my Anycubic Photon M3, but I'm sure good results could be achieved with a FDM printer.

Once post-processed, give it a few coats of white spray paint.
When that is dry, apply masking/painters tape over the details and cutout with a craft knife.
Use a small brush to add paint into the indents (I used acrylic paint). A small needle or pin can be used to spread the paint into the corners and up the sides.