Thingiverse
Loop Quiet Earplugs Keychain Case
door soundbylaura
24
Downloads
28
Likes
0
Makes
UPDATE: Check out the new screw-top lid version here: https://www.printables.com/model/844317-loop-earplugs-screw-top-lid-case
Remixed jecoffey's awesome design, made it a little thinner and a little shorter, removed the loop and put holes in the top for pullchain.
Exterior case prints hole-down with a brim, no supports needed.
Interior holder can print either way down, but if you print holes-down don't use a raft (learn from my mistakes). Minimal supports are needed (see photos).
Don't print them at the same time, PETG is too stringy.
Remixed jecoffey's awesome design, made it a little thinner and a little shorter, removed the loop and put holes in the top for pullchain.
Exterior case prints hole-down with a brim, no supports needed.
Interior holder can print either way down, but if you print holes-down don't use a raft (learn from my mistakes). Minimal supports are needed (see photos).
Don't print them at the same time, PETG is too stringy.
soundbylaura publiceert ook op
51 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
