MakerWorld
Board Games
Zum Modell
Lorcana Hinged Deck Box
20
Downloads
8
Likes
1
Makes
This is a re-make of tjdesign's hinged deck box with the Lorcana name on the top. I used the Giant box and it's more than big enough for your 60+ deck, sleeved. It uses a 6x2 magnet.100mm x 68mm Check out their listing for more info on printing, etc.https://www.printables.com/model/522314-hinged-card-box-button-shy-mtgSlide a piece of filament through the hinge leaving about 1-2mm of excess on each side. Use a flame/heat source to warm the end (1-2seconds max) and then press the hot plastic against a flat surface, locking the hinge into place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
