LOT mirror stand

The basic idea was to develop a simple stand that could hold a thin square mirror -30cm side, like the LOT- at an adjustable tilt angle and with the possibility to rotate the mirror easily and precisely also around the z-axis.
My actual use was to strategically place two of these mirrors on a shelf in my garage so that I could check if I was properly driving my car through the entrance - the garage door is pretty narrow...

The two parts only represent one mirror stand. The other stand can be generated by simply mirroring the parts using the slicer.

Two M4 nuts and four safety washers are required to fix the holders to the respective bases.

The mirror slides tightly into the holder. It can also be fixed in place with a drop of superglue. As shown in the pictures, the mirror should be tilted in the direction of the longest part of the bases.