LOTR: LCG ultimate storage solution

# 3D Printed Insert for Storing *LOTR: LCG*

This is my 3D printing solution for storing *The Lord of the Rings: The Card Game* (LOTR: LCG).

It’s an easy setup: you grab a campaign box and instantly have all the encounter decks for that campaign, without messing up the rest of your collection.

The design is made to fit inside a **Gamegenic: Dungeon 1100+ Convertible**, but you can use any storage solution that fits the box height (including the tabs).

---

## 🧱 The 3D File

- The `.step` file is **parameterized** for easy customization.
- You can change the parameters in Autodesk Fusion 360 by using the **"Change Parameters"** menu (see photo).
- Below is a breakdown of the key parameters you might want to adjust:

### 📏 Sleeve Size
- `sleeve_width` and `sleeve_height`: set these to match the size of your sleeved cards (see reference photo).
- Measure your sleeves and run a few test prints to fine-tune these values. Once defined, you shouldn't need to change them again.
- The