Lovers’ Embrace statue

A sleek, single‑piece sculpture showing two lovers locked in an embrace, with a heart cut‑out at the center. Perfect as a romantic décor piece, a Valentine’s or wedding gift, or an elegant accent for your desk or book‑shelf.🔹 Key FeaturesOne‑piece design: continuous, flowing lines—no assembly.Fully scalable: print it small (8‑10 cm) for a shelf or large (25‑30 cm) as a centerpiece.Material friendly: looks stunning in marble, wood, stone or silk‑finish filament.Paint‑ready: take acrylics or clear coat beautifully if you’d like extra flair.🖨 Recommended Print SettingsSettingValueNozzleØ 0.4 mm standardLayer height0.20 mm (0.16 mm for extra detail)Infill15 – 20 % (Grid or Gyroid)SupportsTree supports only where needed (45‑50 ° overhang)Brim / RaftUsually not requiredMaterialRegular PLA; PETG or PLA+ for very large printsTime~3 h at 150 mm tall (scales with size)Tip: With marble/stone PLA, bump flow +2‑3 % to make layer lines vanish in the speckle. ❤️ Use IdeasElegant décor for living ro