LoveSac Sactional Arm Table

Created this for our Lovesac Sactional couch for a space for small items.

I printed this with a 0.8MM nozzel 0.4mm layer height. You can use smaller nozzles but this will most likely be a multi day print.

printed this on its side with no supports. 45 deg on the table top works great without supports.

This was sized to match the wood cup holer that they sell so it is about the same size.

Printerd with a Creality CR6. This was printed at 40mm/s and found that is a little too fast for a good quality print (at least with my printer) too manny wavy layer lines,i think its just to much plastic to heat up evenly. I re printed this at 20 and 30 mm/s and the layers are nice and even. So 30mm/s with a 0.8mm nozzel seem to be the limit for me.


UPDATED 9/12/22
Added 2 remote holders.

The Arm Tray Remote Holder and Holder V2 are for your average style remotes and hangs off the side of the table. It can be a bit trickey to print but i managed to print mine without supports, just