Thingiverse
Low insertion force hex bit holder
door kbs3056
97
Downloads
90
Likes
0
Makes
Hex shank power bit holder with latching mechanism. Suitable only for bits with an indentation.
Should work printed with an 0.3-0.5mm nozzles when the default model parameters.
Bit shank diameters vary depending on the manufacturer therefore bit should be stored in its own pocket in the holder.
It is good to set the 'hole_diam' parameter for each your bit sets.
Will work with harder filaments like PLA, PETG.
Version 2 has a greater holding force.
Should work printed with an 0.3-0.5mm nozzles when the default model parameters.
Bit shank diameters vary depending on the manufacturer therefore bit should be stored in its own pocket in the holder.
It is good to set the 'hole_diam' parameter for each your bit sets.
Will work with harder filaments like PLA, PETG.
Version 2 has a greater holding force.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
