Thingiverse
Low poly croc trophy (Mr. Croc)
by Andyjoensen
31
Downloads
31
Likes
0
Makes
This is just an idea, which I haven't printed yet but it's should be printable. I would probably suggest tree support for this model.
As said I haven't had time to print this yet, however, I would love too. Therefore I cannot really suggest any supports or layer heights but I would asume a layer height of 0.15mm with tree support and 20% infill should do it if you are up for using that much plastic.
As said I haven't had time to print this yet, however, I would love too. Therefore I cannot really suggest any supports or layer heights but I would asume a layer height of 0.15mm with tree support and 20% infill should do it if you are up for using that much plastic.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!