Thingiverse
Low Poly Mask
von Saleh1421ksa
4
Downloads
18
Likes
0
Makes
I removed few parts to make it easier to print without supports
The raft will be easy to remove
I recommend using the same orientation on the second picture
Probably you will need to scale it up a little. The one I printed is 100% but it is kind of small. If I print another one, I will make it 105-110%
The raft will be easy to remove
I recommend using the same orientation on the second picture
Probably you will need to scale it up a little. The one I printed is 100% but it is kind of small. If I print another one, I will make it 105-110%
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!