Thingiverse
Low Poly Sword Bookmark
von RedFeather_
16
Downloads
60
Likes
0
Makes
Mark your page with valor and style! This 3D-printed sword bookmark is the perfect companion for any book lover, fantasy enthusiast, or adventurer diving into their next literary quest.
Designed to be slim enough to rest comfortably between pages without damaging your book, yet sturdy enough to hold your place, this sleek sword bookmark adds a touch of epic fantasy to your reading experience
Printing Recommendations:
Material: PLA works great and is available in many colors. PETG can be used for extra durability if preferred.
Layer Height: 0.12mm - 0.16mm for good detail on the hilt and blade. 0.2mm is also acceptable for a faster print.
Infill: 20-30% is generally sufficient. For very thin designs or a more solid feel, you can go higher or even use 100%.
Orientation: Print flat on the build plate for best results and strength.
Supports: None needed! This design is optimized for support-free printing.
Bed Adhesion: Using a brim might be helpful, especially for the thinner par
Designed to be slim enough to rest comfortably between pages without damaging your book, yet sturdy enough to hold your place, this sleek sword bookmark adds a touch of epic fantasy to your reading experience
Printing Recommendations:
Material: PLA works great and is available in many colors. PETG can be used for extra durability if preferred.
Layer Height: 0.12mm - 0.16mm for good detail on the hilt and blade. 0.2mm is also acceptable for a faster print.
Infill: 20-30% is generally sufficient. For very thin designs or a more solid feel, you can go higher or even use 100%.
Orientation: Print flat on the build plate for best results and strength.
Supports: None needed! This design is optimized for support-free printing.
Bed Adhesion: Using a brim might be helpful, especially for the thinner par
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!