MakerWorld
Animals
Zum Modell
Low Poly Toothless
163
Downloads
62
Likes
96
Makes
If you'll be printing it small it might mess up the wings since they are thin on the bottom so I suggest printing it larger. I printed it with a bit more infill than is probably needed so feel free to adjust that. Supports are needed for wings and chin and some other bits. I went with Tree Slim and they were a little hard to remove but normal supports should work well too.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
