Thingiverse
Low Polygon Mask - Replicator Printable
di Austin
1.4k
Download
1.4k
Likes
33
Makes
Need a masquerade mask, but just can't quite fit the Low Polygon Mask into your Replicator print volume?
Well, stop fretting and use OpenSCAD to trim some tiny edges off!
2013-01-01: At the last minute I slapped together and printed a stick that worked quite well as a handle (once a little silver duct tape was added on the inside of the mask). It's not perfect, but for being a ten-minute design it worked very well!
2013-01-02: Fixed the gap in the CC license-chain by switching from CC0 to CC-BY-NC-SA.
Well, stop fretting and use OpenSCAD to trim some tiny edges off!
2013-01-01: At the last minute I slapped together and printed a stick that worked quite well as a handle (once a little silver duct tape was added on the inside of the mask). It's not perfect, but for being a ten-minute design it worked very well!
2013-01-02: Fixed the gap in the CC license-chain by switching from CC0 to CC-BY-NC-SA.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!