Thingiverse
Low profile spool holder
von szafainzynier
0
Downloads
1
Likes
0
Makes
originally made for a drybox that was low and I've had only bout a 1cm to work with so this holder will make spool only about 3 or 4 mm higher so it can fit in smaller spaces.
spool_holder.stl file contains full 4 parts ready to print.
-fits spools with 54/55mm side holes (fits eSUN spools)
-2x608 bearring
-anycubic kobra 2
-10% infill
-no supports needed
spool_holder.stl file contains full 4 parts ready to print.
-fits spools with 54/55mm side holes (fits eSUN spools)
-2x608 bearring
-anycubic kobra 2
-10% infill
-no supports needed
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
