Robotics
Zum Modell
Lower Arm - Cut, more easy.
11
Downloads
8
Likes
0
Makes
Normal prusas have a limit of 20x20x20.
If you use support is very weak, it takes a lot.
High failure probabilities.
With this solution you can print each half separately or both in a comfortable way.
You will only need 6 long m4 screws.
If you use support is very weak, it takes a lot.
High failure probabilities.
With this solution you can print each half separately or both in a comfortable way.
You will only need 6 long m4 screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!