Lower trigorilla mount for delta printer

The Trigorilla board that comes with Anycubic linear plus seems a bit too close to the hotbed so I designed a lower mount that also should allow for a better cable management.

The holes on the margins are for zip-ties (2-3 mm width) that will hold the cables in position.

It can be printed at almost any resolution as long as the piece will not fall apart under pressure.
I used 0.4 mm layer height with 20% infill but I would recommend a lower layer height.

This should work with any printer that uses a 2020 extrusion as frame as long as it fits inside.

The shorter version (the one in the pictures) will work fine if you do not need the usb cable. Otherwise you will need to cut a bit of the plastic from the cable stress relief.

The longer version adds 2 cm extra space to allow the usb cable to fit without force.