Thingiverse
LowRider2 - case for Open-CNC-Shield
door TheMaxx2804
20
Downloads
6
Likes
0
Makes
This is another case designed to attach to the Y-plate on the LowRider2 CNC. It fits to the 4 screws on the upper and lower corners of the Y-plate.
In this Version i wanted to integrate the Open-CNC-Shield board from Timo Altholtmann which you can find here:
https://blog.altholtmann.com/open-cnc-shield/
The holes are ready for gx16 connectors and there is also a slot for the connector.
If you do not need all of the gx16 holes then you can use the cap which i added to the print files.
On the cover there are holes prepared for a 120mm and 80mm ventilator. Depending on the fitting of your board you can mount the ventilator inside or outside on the case.
If you have driver installed maybe you have to place the ventilator outside.
In this Version i wanted to integrate the Open-CNC-Shield board from Timo Altholtmann which you can find here:
https://blog.altholtmann.com/open-cnc-shield/
The holes are ready for gx16 connectors and there is also a slot for the connector.
If you do not need all of the gx16 holes then you can use the cap which i added to the print files.
On the cover there are holes prepared for a 120mm and 80mm ventilator. Depending on the fitting of your board you can mount the ventilator inside or outside on the case.
If you have driver installed maybe you have to place the ventilator outside.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
