Thingiverse
LS Brake Booster Vacuum Fitting
von Drake364
3
Downloads
4
Likes
0
Makes
Vacuum brake booster fitting at back of intake for GM gen 3 vortec intakes, simply remove your factory plug and push this one in to use with 1/2" ID hose
Print standing on end in ABS or other high temp material, no support required
If you break it and leave one half stuck in the intake, simply thread a tap or bolt into the remaining piece and remove as normal
Print standing on end in ABS or other high temp material, no support required
If you break it and leave one half stuck in the intake, simply thread a tap or bolt into the remaining piece and remove as normal
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
