Thingiverse
LTT Screwdriver Bit Holder
door Kaltern
25
Downloads
26
Likes
0
Makes
This is a very early WIP - I've tried to get measurements correct but I don't yet have the final item so it may be off. (let me know in the comments!)
Space for 16 bits, each space has a 5 x 2mm round hole for a magnet to be glued into, to hold each bit securely. (can buy these from Amazon)
Thinking of adding a couple of holes on each side for more magnets, to allow a modular design to stick boxes together for more bits.
Let me know what you think, what needs changed etc.
Print with at least 15% infill - the more the heavier. .20mm should be sufficient for quality.
PLA should be more than enough for this.
Space for 16 bits, each space has a 5 x 2mm round hole for a magnet to be glued into, to hold each bit securely. (can buy these from Amazon)
Thinking of adding a couple of holes on each side for more magnets, to allow a modular design to stick boxes together for more bits.
Let me know what you think, what needs changed etc.
Print with at least 15% infill - the more the heavier. .20mm should be sufficient for quality.
PLA should be more than enough for this.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
