LTT Screwdriver Case

I decided to take a stab at making my own case for the LTT screwdriver. Fits 18 extra normal sized bits. The bits fit very well, with the option to glue magnets to the bottom to keep them from falling out. It also opens flat leaving a parts tray.

I used 3/32 think Aluminum TIG welding rod for the hinge pin. I initially was going to use old pop rivet ends, but I had the tig rod and liked the way it looked with a dab of glue on the ends to make sure it stays in place.

The magnets are 5x2mm. (ebay special)

Printed flat side to the bed using PLA with 15% infill.

Some filing may be required for smooth/ease of operation of the snap. I did alter it slightly to try and smooth the transition on the base for the clasp to run over.