Lucy With LED

A little nightlight made from Mere's Lucy the Cat thing.

I created a cavity in the bottom to house the electronics of a tealight. I used an RGB tealight which glows very nicely.

You have to remove the tea light center portion from its outer shell. I did this so that most of the cats body would light up and maintain a lower overall profile. There is a small hole marking the center of the cavity in the bottom. This has to be drilled or punched out to make room for the led.

The cavity is 38mm in diameter which is adequate for most tealights internals.

Parts:
1 led tealight
hot glue or other adhesive

Printing:
2-3 layers, NO INFILL, support touching build plate
I did a layer height of .12