Thingiverse
Learning
Go to Model
Luer Lock M/F Cap
43
Downloads
26
Likes
0
Makes
Double-ended Male/Female Luer Lock Cap. In the image the red parts are printed in FDM while the blue ones are the original injection-molded part.
Fully 3D-printable in FDM in both orientations, no supports required.
Optimized for a 0.4 nozzle, 0.15 layers or *less*.
WARNING: the seal likely won't be air-tight due to imperfections in the printing process. Liquid can also penetrate between micro-fissures between the layers. You must consider if these limitations can affect your experiment.
Cooling and material is extremely important when printing this part accurately: PETG or PP recommended. Always print multiple copies to ensure the material doesn't overheat while printing.
Using a SLS/SLA process *should* result in an air-tight part.
A big shootout to [this page](https://www.sedgeochem.uni-bremen.de/luer%20connector.html) which provided a good basis for the measurements.
Fully 3D-printable in FDM in both orientations, no supports required.
Optimized for a 0.4 nozzle, 0.15 layers or *less*.
WARNING: the seal likely won't be air-tight due to imperfections in the printing process. Liquid can also penetrate between micro-fissures between the layers. You must consider if these limitations can affect your experiment.
Cooling and material is extremely important when printing this part accurately: PETG or PP recommended. Always print multiple copies to ensure the material doesn't overheat while printing.
Using a SLS/SLA process *should* result in an air-tight part.
A big shootout to [this page](https://www.sedgeochem.uni-bremen.de/luer%20connector.html) which provided a good basis for the measurements.
wavexx also publishes on
134 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
