Thingiverse
Lulzbot Filament Guide Cap
door kacey3
7
Downloads
1
Likes
1
Makes
I noticed that the filament guides on my Lulzbot printers were getting chewed up being pulled into the extruder so I created a small cap to fit over the end of the nylon tubing. This provides a stronger end while also preventing it from being pulled into the extruder.
I did have to scale it up to fit over the tubing. Be prepared to do a couple of test prints to get it to fit snugly.
I did have to scale it up to fit over the tubing. Be prepared to do a couple of test prints to get it to fit snugly.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!