Thingiverse
Lulzbot Mini 2 Enclosure
von Solarbotics
5
Downloads
8
Likes
0
Makes
Needing an enclosure for our new Mini-2, we found this [original](https://www.thingiverse.com/thing:1635583) from Printed Solid / drandolfph. Yay for sharing guys. Here's our mods to it to make it Mini-2 compatible.
We've laser-cut out of sheet clear PETG & ABS for much tougher construction (yes PETG clear sheet is just the _slightest_ bit milky but more than good enough), so no over-tightening fears here.
Modification notes are listed on a "notes" layer for easy turning-off. First 2 pages are the "clear" 3mm sheets, the last 2 pages are *optionally* clear, but we used 3mm black ABS sheet. Stinky to cut, but clears up well enough, and is much tougher than acrylic.
Besides the standard 3D prints, don't forget to print the special PrintedSolid [top-right corner mount](https://www.thingiverse.com/thing:2811712) that is designed to clear the control box.
We've laser-cut out of sheet clear PETG & ABS for much tougher construction (yes PETG clear sheet is just the _slightest_ bit milky but more than good enough), so no over-tightening fears here.
Modification notes are listed on a "notes" layer for easy turning-off. First 2 pages are the "clear" 3mm sheets, the last 2 pages are *optionally* clear, but we used 3mm black ABS sheet. Stinky to cut, but clears up well enough, and is much tougher than acrylic.
Besides the standard 3D prints, don't forget to print the special PrintedSolid [top-right corner mount](https://www.thingiverse.com/thing:2811712) that is designed to clear the control box.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
