Lulzbot MOARstruder Mini Mount

****UPDATE***
Ok so the good news it that it works! The bad news is that you have to mess with a couple settings.

Under Machine Settings>Z Offset: -.2 (this will help the first layer stick to the bed (also use a gluestick)

Under the expert settings and the Start.GCODE change it to the following:

;Basic settings: Layer height: {layer_height} Walls: {wall_thickness} Fill: {fill_density}
;Print time: {print_time}
;Filament used: {filament_amount}m {filament_weight}g
;Filament cost: {filament_cost}
;M190 R{print_bed_temperature} ;Uncomment to add your own bed temperature line
;M109 R{print_temperature} ;Uncomment to add your own temperature line
G26 ; clear potential 'probe fail' condition
G21 ; metric values
G90 ; absolute positioning
M82 ; set extruder to absolute mode
M107 ; start with the fan off
G92 E0 ; set extruder po