Thingiverse
Lulzbot Taz Webcam Mount v2
von Scotty-G
9
Downloads
4
Likes
1
Makes
http://www.thingiverse.com/thing:2325641 is the design I am using for my Logitech Webcam.
At work we have a Microsoft Webcam to mount to a Taz, so am creating a version 2 design.
The Microsoft Webcam mounting is different so instead of having 2 bolts down the center of the 2 piece mount clamping block, I made a mount clamping block that has a bolt on either side. I also spruced up the Arm's design a bit and carried over that update to the mounting block.
Am still using wantmys2000's Dropcam Mount (http://www.thingiverse.com/thing:745446) bottom support bracket.
Also, all pieces are printed out of ABS due to the proximity of the heated bed.
Will need to print 2 of the Arms and rotate all pieces so that they lay flat. For the bottom support bracket, print with supports so the mounting ends are stronger due to the outline being drawn with a 2mm thick wall.
I used x6 M3 heat-set inserts (https://www.mcmaster.com/#94180a333/=17nqddx),
x4 M3 10mm hex screws (https://www.mcm
At work we have a Microsoft Webcam to mount to a Taz, so am creating a version 2 design.
The Microsoft Webcam mounting is different so instead of having 2 bolts down the center of the 2 piece mount clamping block, I made a mount clamping block that has a bolt on either side. I also spruced up the Arm's design a bit and carried over that update to the mounting block.
Am still using wantmys2000's Dropcam Mount (http://www.thingiverse.com/thing:745446) bottom support bracket.
Also, all pieces are printed out of ABS due to the proximity of the heated bed.
Will need to print 2 of the Arms and rotate all pieces so that they lay flat. For the bottom support bracket, print with supports so the mounting ends are stronger due to the outline being drawn with a 2mm thick wall.
I used x6 M3 heat-set inserts (https://www.mcmaster.com/#94180a333/=17nqddx),
x4 M3 10mm hex screws (https://www.mcm
Scotty-G veröffentlicht auch auf
38 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
