Thingiverse
Engineering
Zum Modell
Lunokhod rover
1
Downloads
3
Likes
0
Makes
I made this as a model for my National History Day project in school. I managed to print it, though it took a few tries. I recommend using a resin printer, though, since most of the overhangs are very difficult for a FDM printer to take.
**NOTE:** The GCODE included is fit for a reality cr-10s pro/pro v2, though i am not sure if other printers can use the Gcode.
**NOTE:** The GCODE included is fit for a reality cr-10s pro/pro v2, though i am not sure if other printers can use the Gcode.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
