M-LOK Flashlight holder

M-Lok Flashlight holder. This is designed for the $13 flashlight (588 Lumen) that they sell at Harbor Freight.
https://www.harborfreight.com/588-lumen-tactical-flashlight-63934.html

You'll need to get M-Lok screws (Amazon has them) and you'll also need a screw and nut (nut recess is designed for 8mm across flats) to tighten the clamp.

Print with the rail side down, and use supports everywhere. For this print I can recommend that you can go as high as 70º for the overhang angle. Just enough to support the ring at the top. 100% infill would probably be best, although it would probably be just fine with less.