Thingiverse
M10 Barb hose fitting
von superdave42
28
Downloads
15
Likes
0
Makes
My Airpump for my laser cutter did not come with the air fitting, and I needed one quickly so I made this. I printed it in PLA and wrapped some teflon thread tape and screwed it into the compressor.
The compressor gets warm and softened the PLA print. I had to support the air hose so it did not put a force on this fitting when it was warm, used it for 3 days in a row so far no leaks.
use at your own risk :-)
The compressor gets warm and softened the PLA print. I had to support the air hose so it did not put a force on this fitting when it was warm, used it for 3 days in a row so far no leaks.
use at your own risk :-)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!