M2.5 Wrench

This little M2.5 wrench is designed to hold nuts in place during assembly.Use your normal driver for tightening. Since it’s plastic, cranking on it will strip it, but used properly it works great.One end is open so you can reach into tight spots, the other holds the nut securely in a small pocket. The best part: you can store it inside the PT6’s oil tube.Push it into the oil cap and it stays right there. Instead of disappearing in a drawer. It even doubles as the dipstick. It’s useful for past and future engine builds. I try using the same nut size across all projects. Get notified about new project releases here.Happy printing and great success! Message me with any questions! Boost MeYour support keeps me going! Thanks ⚡ Designed by linus3dMy website: https