Thingiverse
M2 Micro Machinist Jack
von mrmaigo
3
Downloads
3
Likes
0
Makes
Needed to level a project real quick/dirty and all I had is some M2 caphead screws and some nuts.
Height Range: 31 to ~53mm
M2 caphead screws 10-25mm, M2 nuts
Print with brim. 37 minutes/1.86m at 0.3mm/50mms/3walls
Update 1: First one turned out fine, second print not so much, didn't like the overhang for the nut. Guessing the temp was too high for a different filament. Little tweaky-tweaky.
Height Range: 31 to ~53mm
M2 caphead screws 10-25mm, M2 nuts
Print with brim. 37 minutes/1.86m at 0.3mm/50mms/3walls
Update 1: First one turned out fine, second print not so much, didn't like the overhang for the nut. Guessing the temp was too high for a different filament. Little tweaky-tweaky.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
