Thingiverse
M20 Screwhandle
von FauxLifeForReal
0
Downloads
0
Likes
0
Makes
An M20 bolt with attached handle for you to 3d Print. The Thread is reduced on both sides by 0.1 mm for tolerance, otherwise it threads in too tight.
Make sure to split the part and change to higher infill for the bolt part of the print to improve strength and prevent snapping. It can also used upside down if you want to glue in a steel bolt with a hex head. That is not tested though.
Can be printed without supports.
I have used this in my DIY Lighting Rig build which you should check out here:
https://youtu.be/Z6hWZ7HpHdo
It has been holding on great so far!
Make sure to split the part and change to higher infill for the bolt part of the print to improve strength and prevent snapping. It can also used upside down if you want to glue in a steel bolt with a hex head. That is not tested though.
Can be printed without supports.
I have used this in my DIY Lighting Rig build which you should check out here:
https://youtu.be/Z6hWZ7HpHdo
It has been holding on great so far!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!