Thingiverse
M249 Para suppressor adapter
door citruspers
40
Downloads
34
Likes
0
Makes
This is an to fit a suppressor on an airsoft M249 Para. On the stock setup the gas key prevents a suppressor from being mounted, so I designed this small barrel extension.
Compatibility: tested to fit on my Classic Army M249, which should mean that it will fit the A&K M249 as well. Threading is 14mm CCW on both ends.
Printing instructions:
Print with the largest flat side down at 0.1mm resolution (same orientation as the picture).
Printing threads isn't easy, you need a well calibrated printer and good cooling (or print multiple adapters at the same time). If it doesn't fit you may need to scale the print up or down by 1% or so.
No supports needed
I printed this in PA6+CF filament and it seems fine, but your mileage may vary and you are using this at your own risk.
.stp file included
Compatibility: tested to fit on my Classic Army M249, which should mean that it will fit the A&K M249 as well. Threading is 14mm CCW on both ends.
Printing instructions:
Print with the largest flat side down at 0.1mm resolution (same orientation as the picture).
Printing threads isn't easy, you need a well calibrated printer and good cooling (or print multiple adapters at the same time). If it doesn't fit you may need to scale the print up or down by 1% or so.
No supports needed
I printed this in PA6+CF filament and it seems fine, but your mileage may vary and you are using this at your own risk.
.stp file included
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
