Thingiverse
M365 U-Lock Holder flat
by builder_bob
25
Downloads
28
Likes
1
Makes
Xiaomi M365 Special holder for random U-Locks
Design made it flat along the side of the frame.
Very simple to just push it in and release it. Yet it sits very firmly. Easy access is the key, and also that it is a clean design following the frame.
For the holders to sit firmly, use some rubber on the inside, (i'ts calculated for a rubber of ~0,8mm)
Design made it flat along the side of the frame.
Very simple to just push it in and release it. Yet it sits very firmly. Easy access is the key, and also that it is a clean design following the frame.
For the holders to sit firmly, use some rubber on the inside, (i'ts calculated for a rubber of ~0,8mm)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
