Thingiverse
M365 vertical stand
door brieru
9
Downloads
16
Likes
0
Makes
Vertical stand for xiaomi, optional 8mm inner diameter (ID) bearings or 8mm ID rollers, like skateboards ones, could be installed.
Take care to align the m365 folding mechanism (lower part) with this print, the m365 screw need to go where there is a recession in the 3d print.
needed:
1 x M8 threaded rod, length depending on what you put to the two ends, approx 220mm if nothing installed at the end.
2 x M8 washer and nut
1 x M5 x 40/50mm screw
1 x M5 nut
1 x 5mm drill bit to drill precisely the 5mm hole if nedded
Take care to align the m365 folding mechanism (lower part) with this print, the m365 screw need to go where there is a recession in the 3d print.
needed:
1 x M8 threaded rod, length depending on what you put to the two ends, approx 220mm if nothing installed at the end.
2 x M8 washer and nut
1 x M5 x 40/50mm screw
1 x M5 nut
1 x 5mm drill bit to drill precisely the 5mm hole if nedded
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
