m3Dave_Elegoo_Centauri_Carbon_Manual_Leveler_Bracket

This model is designed to quickly and easily clip onto the Elegoo Centauri Carbon x axis rails to mount a digital dial gauge for flatness/level measurements. This is useful when checking your bed for manual leveling, or for extremely precise calibration to each build plate even.



The specific gauge used here is the generic "allmeter" brand found on Amazon (https://www.amazon.com/dp/B0D4YWQ9MF), however any brand following this design should work fine.



The bracket is designed to be printed twice, and then simply flipped and rotated, allowing the gauge and both sides to slide together over the rails with no fasteners and easy removal once complete.



To measure level, move the print head to the extremes of the x axis, mount the bracket, and then y to each extreme. The bracket easily slides along the length of the rail without requiring any removal during measurement. This will measure each of the four corners allowing you to adjust as necessary for ultra precise levelling.