Thingiverse
M4 magic pin - rear
von branexius
2
Downloads
4
Likes
0
Makes
This is a rear magic pin for airsoft M4 type guns. This pin tightens the connection between the lower receiver and the gearbox. It is too short to use as a front pin. Solidworks file from SW2016.
Clean up (flatten) the points where the segments are connected with a file. For tightening I used an M3x30. The hex goes into the provided socket and the bolt head to the "narrow" part of the pin.
Just print it in whichever direction. I printed it with the wide part on the top.
Also available on [Grabcad](https://grabcad.com/library/magic-pin-rear-3d-print-1).
Clean up (flatten) the points where the segments are connected with a file. For tightening I used an M3x30. The hex goes into the provided socket and the bolt head to the "narrow" part of the pin.
Just print it in whichever direction. I printed it with the wide part on the top.
Also available on [Grabcad](https://grabcad.com/library/magic-pin-rear-3d-print-1).
branexius veröffentlicht auch auf
3 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
